How do I control the SNOObear?

SNOObear is a cuddly teddy bear that brings your little one’s favorite responsive white noise from SNOO. Here is how you set up the white noise to be just what your baby or toddler needs.

Time Limit for White Noise

SNOObear will play white noise for 30 or 60 minutes when you first press play. This will allow your little one time to fall asleep. After this time, SNOObear will listen for 3 additional hours and will begin to play white noise when your baby or toddler fusses, helping soothe them back to sleep.

You can adjust the time limit for the white noise on the module inside SNOObear:

mceclip0.png

Controlling the White Noise

Your SNOObear can be controlled by pressing the two buttons located on the sides of the sound module inside the bear. Button A is positioned on the opposite side of the timer switch, and button B is on the opposite side of the speaker.

When you place the module inside the bear, position it to have button B facing the front of the bear, and button A positioned towards the bear’s right side.

 

Play: Press the A button once

Stop: Press the A button twice

Cycle Volume: Hold the A button for 3 seconds

Skip White Noise Track: Press the A and B buttons at the same time

mceclip1.png

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.